IBM AS/400 Hardware User Manual page 71

AS/400 Prompt
LAN adapter address ADPTADR
Connection type CNN
Destination service DSAP
access point
Duplex DUPLEX
FBSS
AS/400 Configuration
Parameter Display
Token Ring
Communications
SDLC
Communications
Token Ring
Communications
SDLC
Communications
PC address
If the AS/400 system uses a Token-Ring network line
to connect to the FBSS controller, values specified for
the FBSS and on the ADPTADR parameter on the
CRTLINTRN command must match.
If the AS/400 system uses an Ethernet line through
an 8209 LAN Bridge, see "Appendix C: Local Area
Network Addressing Considerations" in the
Communications Configuration
Host/37xx/4700 address
If the AS/400 system uses a Token-Ring network line
to connect to the FBSS controller, values specified for
the FBSS and on the ADPTADR parameter on the
CRTLINTRN command must match.
If the AS/400 system uses an Ethernet line through
an 8209 LAN Bridge, see "Appendix C: Local Area
Network Addressing Considerations" in the
Communications Configuration
Switched line
Values specified for the FBSS and AS/400
configurations must match:
v If the FBSS response is
be specified for the CRTLINSDLC command and
SWITCHED(*YES) for the CRTCTLFNC command.
v If the FBSS response is
CNN(*MP) must be specified for the CRTLINSDLC
command and SWITCHED(*NO) for the
CRTCTLFNC command.
Service access point for PC
Values specified for the FBSS and for the DSAP
parameter on the CRTCTLFNC command must
match.
Line mode
Values specified for the FBSS and AS/400
configurations must match:
v If the FBSS response is
DUPLEX(*HALF) must be specified for the
CRTLINSDLC command.
v If the FBSS response is
to send), DUPLEX(*FULL) must be specified for
the CRTLINSDLC command.
Chapter 7. Communicating with remote workstation controllers
FBSS Prompt
book.
book.
, CNN(*SWTPP) must
, CNN(*NONSWTPP) or
,
(Continuous request
65