IBM AS/400 Hardware User Manual page 72

AS/400 Prompt
Exchange identifier EXCHID
Link type LINKTYPE
Local location address LOCADR
NRZI data encoding NRZI
Source service access SSAP
point
SSCP identifier SSCPID
Station address STNADR
66
Version 5
FBSS
AS/400 Configuration
Parameter Display
SDLC
Communications
Communication
Servers
Session-Id and LU
Assignments
LU Assignments
for Display
Emulators
LU Assignments
for 3287 Printer
Emulator
SDLC
Communications
Token Ring
Communications
SSCP Names
SDLC
Communications
FBSS Prompt
Identification block and Identification number
The values specified for the FBSS controller must
match the value specified in the EXCHID parameter
of the CRTCTLFNC command. The EXCHID
parameter must be specified as:
matches the FBSS Identification block and
matches the FBSS Identification number.
Data Link Control
Values specified for the FBSS and AS/400
configurations must match:
v If the FBSS response is
must be specified for the CRTCTLFNC command.
v If the FBSS response is
must be specified for the CRTCTLFNC command.
v If the FBSS response is
must be specified for the CRTCTLFNC command.
Host Logical Unit Numbers
FBSS logical unit number must match the LOCADR
parameter value specified on the CRTDEVFNC
command.
The FBSS logical unit assignments are decimal
numbers; the AS/400 values must be hexadecimal.
Host Logical Unit Numbers
FBSS logical unit number must match the LOCADR
parameter value specified on the CRTDEVDSP or
CRTDEVPRT command for 3270 devices attached to
the FBSS controller.
The FBSS logical unit assignments are decimal
numbers; the AS/400 values must be hexadecimal.
N.R.Z.I.
Values specified for the AS/400 CRTLINSDLC
command and the FBSS controller must match.
Service access point for Host/37xx/4700
Values specified for the FBSS and for the SSAP
parameter on the CRTCTLFNC command must
match.
SSCP namexx
If used, the value specified for the FBSS controller
must match the last 10 digits of the SSCPID
parameter on the CRTCTLFNC command.
Station address
Values specified for the AS/400 CRTCTLFNC
command and the FBSS controller must match.
, where
, LINKTYPE(*SDLC)
, LINKTYPE(*LAN)
, LINKTYPE(*X25)