Table of Contents
Advertisement
YOYOCam Settings
Master, Users & Guests
YOYOCam has three levels of user:
Master: has complete control over YOYOCam, receives alarms & notifications, and can
request images.
User: has some control over YOYOCam and can request images.
Guest: can request images using the Password supplied by the Master.
Master
The Master has complete control over YOYOCam and can use any command. The Master sets up
Users and configures YOYOCam as required. There is one Master. If necessary, someone else can
be the initial Master and perform the configuration, then use the Change Master Number command to
hand YOYOCam to the person who will be Master.
YOYOCam leaves the factory with no Master user defined. Performing a Factory Reset operation
also clears the Master user, and it must be set again as if for the first time.
To set Master user for the first time:
From your mobile phone, either:
1. Send an SMS with text #00# to YOYOCam.
2. YOYOCam confirms your phone as Master by SMS, Välkommen till YOYOCam. Lösen är
'1234', (Welcome to YOYOCam. The default password is 1234.) You are now the Master and
have full control over YOYOCam.
Error Responses
MASTER phone number
already exists
To change Master number:
Command:
#14#NewMasterNumber#
Example:
#14#+46702222222#
Response:
New MASTER phone number is +46702222222
Note: response is sent to the old master number. No response is sent to the new Master number.
YOYOCam G3 User Guide v0.2
YOYOCam already has a Master number configured.
Note: YOYOCam gives this response if you send #00# from the
configured Master phone.
From the Master's or a User's mobile phone, you can send the #07#
Check Status & Settings command to get the Master number. If you
have lost the Master number, you must perform a Factory Reset and
reconfigure YOYOCam from the beginning.
Page 26
Advertisement
Table of Contents
