Table of Contents
Advertisement
Sensor Settings for more information.
When a sensor triggers the alarm, YOYOCam sends an SMS to the Master followed by an MMS with
images. Other options include voice call and E-Mail alarms.Detector, image and alarm settings can be
configured. For more information, see Alarm Settings.
STEP 4 – Refine YOYOCam Settings
Here are some of the settings that you may like to change in order to configure YOYOCam to your
needs.
Optimize image settings
By default, YOYOCam takes five images at an interval of 0.5 seconds between each shot. The image
size is 320 x 240 pixels. You may wish to have fewer images at higher resolution, e.g.2 images at 640
x 480 pixels. (2 images is the maximum at this resolution).
Command:
#33#2#
Response:
Number of Alarm images has been set to 2
Command:
#32#3#
Response:
Image size has been reset to 3
For more information, see Image settings.
Configure the sensors which detect an alarm condition
By default, YOYOCam detects movement using the infrared body sensor. Camera movement
detection is also available.
Infrared Body Sensor:
Turn On:
#118#1#
Response:
Infrared sensor - enabled
Turn Off:
#118#0#
Response:
Infrared sensor – disabled
Camera Motion Detection:
Turn On:
#22#1#
Response:
Motion detection - enabled
Turn Off:
#22#0#
Response:
Motion detection – disabled
For more information, see
(Default)
(Default)
16
(Size 3 = 640 x 480 pixels)
Advertisement
Table of Contents
