Table of Contents
Advertisement
Sensor Settings
You can set up which sensors trigger the alarm when YOYOCam is armed.
Infrared Body Detector
The infrared body detector works by detecting the heat emitted from a body moving in front of it.
Turn On:
#118#1#
Response:
Infrared sensor - enabled
Turn Off:
#118#0#
Response:
Infrared sensor – disabled
Note: When YOYOCam is operating on low battery, the infrared body detector is automatically
disabled. It is not possible to re-enable it until the battery has been charged or external power is
connected.
Camera Motion Detection
YOYOCam takes images periodically and compares the latest image with the previous one. If there is
a significant difference, YOYOCam assumes something has moved, for example a person has
walked in front of the camera. YOYOCam raises the alarm.
Turn On:
#22#1#
Response:
Motion detection - enabled
Turn Off:
#22#0#
Response:
Motion detection – disabled
Note: The number of pictures sent after motion detection is by default set to 5.
Note: Command #142#0# will set the number of pictures at motion detection to be the same as the
number of pictures at IR detection.
Note: When YOYOCam is operating on low battery, the camera movement detector is automatically
disabled. It is not possible to re-enable it until the battery has been charged or external power is
connected.
Note: Be careful to position YOYOCam so that there is no unwanted motion in view, for example a
tree shaking in the wind or a cat jumping in to the field of vision.
Note: By default the IR LEDs will be constantly lit when the Camera Motion Detection is activated and
the surrounding light is poor.
YOYOCam G3 User Guide v0.2
(Default)
(Default)
Page 29
Advertisement
Table of Contents
