Table of Contents
Advertisement
STEP 4 – Refine YOYOCam G3 Settings
Here are some of the settings that you may like to change in order to configure YOYOCam to your
needs.
Optimize image settings
By default, YOYOCam takes five images at an interval of 0.5 seconds between each shot. The image
size is 320 x 240 pixels. You may wish to have fewer images at higher resolution, e.g.2 images at 640
x 480 pixels. (2 images is the maximum at this resolution).
Command:
#33#2#
Response:
Number of Alarm images has been set to 2
Command:
#32#3#
Response:
Image size has been reset to 3
For more information, see Image settings.
Configure the sensors which detect an alarm condition
By default, YOYOCam detects movement using the infrared body sensor. Camera movement
detection is also available.
Infrared Body Sensor:
Turn On:
#118#1#
Response:
Infrared sensor - enabled
Turn Off:
#118#0#
Response:
Infrared sensor – disabled
Camera Motion Detection:
Turn On:
#22#1#
Response:
Motion detection - enabled
Turn Off:
#22#0#
Response:
Motion detection – disabled
For more information, see Sensor Settings.
Configure how YOYOCam signals alarms
By default, YOYOCam sends SMS and MMS to the Master when an alarm is triggered. You can also
send alarms by E-mail and voice calling. Additionally, YOYOCam can be set to bleep when the alarm
is triggered. For more information, see Alarm Settings.
The Status Indicator also blinks rapidly while sending the alarm messages. Send #143#0# to disable
it.
YOYOCam G3 User Guide v0.2
(Default)
(Default)
(Size 3 = 640 x 480 pixels)
Page 16
Advertisement
Table of Contents
