Table of Contents
Advertisement
To enable/disable SMS notification at automatic arm/disarm
YOYOCam can inform by SMS when automatic arm or disarm takes place.
Turn on:
#176#1# (Default)
Turn off:
#176#0#
Dial in and listen to audio
Master and Users can dial in to YOYOCam and listen to the audio picked up by the built-in
microphone. YOYOCam is silent throughout this operation – you cannot be heard.
1. Dial YOYOCam's number (voice call)
2. Call rings at YOYOCam for approximately 10 seconds
3. YOYOCam answers and audio from YOYOCam can be heard.
4. Hang up the call to end listening.
Note: Only one person can dial in and listen at once.
Note: YOYOCam cannot send SMS or MMS while a call is connected.
Note: Non-registered callers will get a busy tone. (Only Master and Users can listen in).
Note: The calling phone must be configured to reveal its number to the called party. In some cases
(e.g. company switchboard) the ID sent when calling out may be different to the user's number.
Request Images from YOYOCam
Master, Users and Guests can request images from YOYOCam at any time. YOYOCam can also be
set to automatically send images according to a timetable.
Request one image
To request a single image to be sent to your mobile by MMS:
Command:
#03#
Response:
MMS message containing the image
Note: The image size is the size set by the Image Size setting (default 320 x 240)
See Image settings
YOYOCam G3 User Guide v0.2
Page 22
Advertisement
Table of Contents
