Step 3. Set Up Yoyocam G3 - YOYOMOTION YOYOCam G3 User Manual

STEP 3. Set Up YOYOCam G3

1. Plug the power adaptor in to an AC outlet.
2. Slide the power switch to the ON position to turn on YOYOCam
3. After approximately 40 seconds, YOYOCam bleeps to indicate that the GSM network has
been found.
4. From your mobile phone, send an SMS with text #00# to the mobile number of YOYOCam's
SIM card. YOYOCam confirms your phone as Master by SMS, meaning that you have full
control over YOYOCam.
5. The SMS responses are in Swedish when a
Swedish SIM is inserted, otherwise English.
Send #127#1# to switch to English.
6. Network MMS settings are configured
automatically for the major networks. If your
network operator is in the table to the right,
you must now send the command indicated
in order to configure MMS.
7. Arm YOYOCam
• Send an SMS with text #01# to arm
YOYOCam
• Send an SMS with text #02# to disarm YOYOCam
YOYOCam is now operational.
When armed, YOYOCam will raise the alarm when a sensor is triggered. By default, the built-in
infrared body sensor is enabled and camera movement detection is disabled. When built-in
sensor triggers the alarm, YOYOCam sends an SMS to the Master followed by an MMS with
images. Other options include voice call and E-Mail alarms. Detector, image and alarm setting
can be configured. For more information, see Alarm Settings.
YOYOCam G3 User Guide v0.2
Network Operator
ACN
Cell Mobile SE
Chess NO
Glocalnet
Halebop
Parlino
Superstar
TDC Song NO
TDC Song SE
Telmore DK
Universal
Ventelo NO
Ventelo SE
Command to send
#145#ACN#
#145#CELLMOBILE#
#145#CHESSNO#
#145#GLOCALNET#
#145#HALEBOP#
#145#PARLINO#
#145#SUPERSTAR#
#145#TDCNO#
#145#TDCSE#
#145#TELMORE#
#145#UNIVERSAL#
#145#VENTELONO#
#145#VENTELOSE#
Page 15