Getting Material To Flow - Titan 100 Owner's Manual

3. Getting
Material to
Flow
Start
You will need:
• Waste bucket
• Scrap material / cardboard
• Drop cloths to protect floors and
furnishings from overspray
note: Motor will cycle ON and OFF while
spraying to regulate pressure. This is normal.
5
5. Thread the spray tip guard
assembly onto the gun.
Tighten by hand.
1
1. Point the spray gun into a
separate waste container.
Unlock the spray gun trigger.
Squeeze and hold trigger
for steps 2-3.
6
OR
6. Rotate spray tip forward to one of the
SPRAY positions.
Unlock the spray gun trigger.
2 3
ON
SPRAY
2. Turn the power ON. 3. Continue to squeeze
trigger until the material
Turn the PRIME/SPRAY
is flowing freely through
knob to SPRAY.
the spray gun.
7
ON
SPRAY
7. Turn the power ON.
Turn the PRIME/SPRAY
knob to SPRAY.
9
4
4. Peform the Pressure
Relief Procedure,
page 7.
8
SPRAY
8. Point the spray gun at a piece of
scrap material/cardboard.
Pull the trigger and practice spraying
(see pages 10-11).
note: Motor will cycle ON and OFF while
spraying to regulate pressure. This is normal.
English