Clean The Spray Gun Filter - Titan 100 Owner's Manual

Spraying
Troubleshooting -
Clean the Spray
Gun Filter
Start
You will need:
• Wrench
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
• Replacement spray gun filter (if necessary)
ImPORTanT: never clean the filter by
poking it with a sharp object.
4
4. Remove the filter from the
housing. Clean with appropriate
cleaning solution (warm, soapy
water for latex materials; mineral
spirits for oil-based materials).
1
1. Peform the Pressure
Relief Procedure, page 7.
5
5. Inspect the filter for
damage. Replace if any
holes or tears are found.
13
2
2. Pull trigger guard
from filter housing.
6
6. Replace cleaned filter, tapered
end first, into the gun housing.
note: It is important to place
tapered end first to ensure proper
sprayer operation.
3
(a)
3. Tighten the wrench over the
wrench flats (a). Unscrew the
filter housing using a wrench.
note: You DO NOT need to
remove the spray hose from the gun
to clean the filter.
7
7. Reassemble the spray gun.
English