Clean The Inlet Filter - Titan 100 Owner's Manual

Spraying
Troubleshooting -
Clean the
Inlet Filter
Start You will need:
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
ImPORTanT: make sure your floors and
furnishings are covered with drop cloths
to prevent accidental drips.
English
1
1. Unscrew the inlet filter from the fitting
on the end of the suction tube.
3
3. Replace the cleaned filter by
threading it back into the fitting on the
end of the suction tube.
14
2
2. Clean the filter using the appropriate
cleaning solution (warm, soapy
water for latex materials, mineral
spirits for oil-based materials).
note: If after completing all of the steps
in Spraying Troubleshooting you are still
experiencing problems spraying, refer to
the Troubleshooting section (page 22).