Connecting The Material Hose; Hose Configurations - Titan 0524038 Operating Manual

Hlvp transfer pump airless, high-pressure spraying unitc
Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT: Make sure the siphon tube is firmly inserted into
the inlet fitting, past the O-ring as shown below. If the tube is
not fully inserted, a seal will not be achieved and the pump will
not prime. DO NOT insert the notched end of the suction tube
into the inlet fitting.
NOTE: The siphon tube should go into the inlet
approximately 3/4" in order to be fully inserted.
O-ring
Inlet tting
Siphon
tube
~3/4" (19 mm)
6. If desired, attach the siphon filter at the notched end of the
siphon tube (the larger tube). The filter will prevent any debris
in the spray material from getting into the pump.
Siphon tube
Notch
Siphon lter
7. Make sure the electrical service is 120V, 15 amp minimum.
8. Plug the turbine power cord into a properly grounded outlet
at least 25' from the spray area.

Connecting the Material Hose

1. Thread the end of the fluid hose onto the Transfer Pump fluid
outlet and tighten with a wrench.
2. Thread the other end of the material hose onto the spray gun
inlet and tighten with a wrench.
© Titan Tool. All rights reserved.
Incorrect
Correct
Outlet valve
Fluid hose
Spray gun
Inlet
Fluid hose

Hose Configurations

Spraying without whip hoses
Follow the configuration below if you want to spray without the fluid
and air whip accessories.
Fluid
hose
Straps
NOTE: When strapping the hoses together, start at the spray
gun and work your way back.
NOTE: 30 ft fluid hose - included with Transfer Pump
30 ft air hose - included with turbine (25 ft air hose
included with CS75)
Hose straps - included with Transfer Pump
Spraying with whip hoses
Follow the configuration below if:
1. You already have the air whip hose and you purchased a fluid
whip hose kit.
2. You have purchased both the fluid whip hose kit and the air
hose whip kit.
Fluid hose
Air whip
hose
Fluid whip
hose
NOTE: When strapping the hoses together, start at the
spray gun and work your way back.
NOTE: 30 ft fluid hose - included with Transfer Pump
30 ft air hose - included with turbine
5 ft air whip hose - included with the CS105 and
CS115
5 ft fluid whip hose - sold separately.
5
Air hose
Air hose
Straps
English

Advertisement

Table of Contents
loading

Table of Contents