Cleanup - Oil-Based Materials - Titan 100 Owner's Manual

Cleanup -
Oil-Based
Materials
You will need:
Start
• Mineral spirits if using oil-based material
• Warm, soapy water if using latex material
• Waste container
Follow these steps if you sprayed oil-based
materials, or if you sprayed latex materials
and do not have a garden hose available.
Be sure to use the appropriate cleaning
solution for the type of material sprayed.
4
4. Point the spray gun at the side of
a waste container.
ground the gun against the
side of a metal waste container
if flushing with mineral spirits.
English
1
1. Perform Pressure Relief
Procedure (page 7).
5
ON
SPRAY
5. While squeezing the
trigger, turn the power
ON, and turn the PRIME/
SPRAY knob to SPRAY.
18
2
2. Remove the spray tip
and place into an empty
waste container.
6
6. Continue squeezing the trigger
until fluid is coming out clear.
You may need to get new
cleaning solution.
3
3. Submerge suction set into a
bucket with the appropriate
cleaning solution.
7
7. Perform Pressure Relief
Procedure, page 7.
If you flushed the sprayer with mineral
spirits repeat the steps on this page
using warm, soapy water.