Load Material - Titan 100 Owner's Manual

2. Load
Material
Start
You will need:
• The material you plan to spray
• Flat blade screwdriver
(cart models only)
• Piston Lube™
• Extension cord
• Waste bucket
4
4. Fully depress the
Sureflo™ valve to
make sure the inlet
ball is free.
English
1
1. Remove AutoOiler cap with a
flat blade screwdriver.
Squirt Piston Lube into the
AutoOiler. Replace cap.
5 6
(a)
(b)
5. Place a full container 6. Slide the PressureTrac™ to
of spraying material
underneath the suction
tube (a).
Hold the return tube into a
waste container (b).
Cart MODEl ONlY
2
(a)
2. Push AutoOiler button 2-5 times
to lubricate the fluid section.
Press button 2-3 times before
every use. Be sure to check
reservoir level (a) and refill as
necessary.
7
7. Plug in the sprayer and
maximum pressure (+).
Turn the PRIME/SPRAY
knob to PRIME.
8
StaND MODEl ONlY
3
3. Squirt a teaspoon of Piston
Lube™ (P/N 314-480 or
0516750, sold separately) into
the indicated area.
Light household oil can be
substituted if necessary.
8
ON
8. Switch the pump OFF (O).
move the ON/OFF switch
Place return tube back into
to the ON (l) position.
material container and clip
allow pump to run until return tube and suction tube
you see spray material
together.
flowing from the return
tube.