Proper Use And Functions - Titan 100 Owner's Manual

Proper use
and functions
Start
Capability:
Sprays a variety of paints (oil-based and
latex), primers, stains, preservatives and other
nonabrasive materials.
Do not use!
This pump should not be used with textured
materials, block filler, asphalt sealer or
materials containing HHC. See coating supplier
if flash point is not listed on the container
Safety features:
Spray gun trigger lock and pressure diffuser;
built-in tip safety guard; PRIME/SPRAY knob
for safe pressure release. Conforms to UL STD
1450. Certified to CAN/CSAC 22.2 NO 68-92
Specifications:
Capacity:
100............. Up to .29 gallon (1.1 liter) / min
200............. Up to .33 gallon (1.25 liter) / min
Power source:
100............. 1/2 Hp universal motor
200............. 5/8 Hp universal motor
Power requirement: 15 amp minimum circuit
on 115 VAC, 60 Hz current
generator power requirement: 8000 Watt
ON/OFF switch:
The ON/OFF switch turns power
to sprayer on and off.
(O=OFF, |=ON)
PRIME/SPRAY knob:
The PRIME/SPRAY knob directs
SPRAY
material to the material return
tube when set to PRIME or to
spray hose when set to SPRAY.
Spray hose:
The spray hose connects the
spray gun to the pump.
Spray gun:
The spray gun controls the
delivery of the material being
pumped.
AutoOiler (200 only):
The AutoOiler is designed to
provide lubrication to the fluid
section of the pump.
Sureflo Valve:
The Sureflo Valve is designed
to keep the inlet valve open and
from sticking to dried materials.
The Sureflo Valve is activated
manually by the user.
5
Controls and Functions
WIDE
LX-50
(a)
PressureTrac:
The PressureTrac™ regulates
the amount of force the pump
uses to push the fluid and can
be adjusted for desired spray
pattern.
TR 2 spray tip:
The TR spray tip can be
2
adjusted based on your spraying
needs.
Trigger lock:
Engage the trigger lock whenever
the gun is not in use.
LX-50 - The gun is locked
when the trigger lock is at a
90º angle (perpendicular to the
trigger in either direction).
Suction tube (a):
The suction tube draws the fluid
from the original container into
the pump.
Material return tube (b):
Fluid is sent out through the
return tube and back into the
(b)
original container when the
PRIME/SPRAY knob is in the
PRIME position.
English