Titan 100 Owner's Manual page 17

5 6
5. Remove the inlet filter from 6. Thread pump cleaning
the suction tube and place
it into waste container.
9
9. Point the spray gun at the side of
a waste container.
7
7. Unclip the return tube from the suction tube
adapter onto garden hose. and place it into the waste container. Turn
Thread suction tube fitting the PRIME/SPRAY knob to PRIME.
over the adapter.
10
SPRAY
10. While squeezing the trigger, turn the
PRIME/SPRAY knob to SPRAY.
11
11. Continue squeezing the trigger
until fluid is coming out clear.
17
8
ON
8. Turn the water supply to the garden hose on.
Turn the pump ON.
Water will go into the suction tube and out
through the return tube. Let the pump run
for a few minutes, and leave pump running
for next steps.
12
12. Perform Pressure Relief
Procedure, page 7.
Move on the Cleaning the Spray
gun Components, page 19.
English