Warning - Emerson SOUTHTOWNE CF4900BS00 Owner's Manual

BP7485 Southtowne CF4900
3.7
Screw two #8-32 x 1-1/4" threaded studs (provided) into
the motor (Figure 7).
Leave approximately 7/8" of the stud extending above
the motor.
3.8
NOTE: Make sure the red and brown leads are
capped with wire connectors. During installation of
coupler cover, be sure the red, brown and yellow
wires and wire connectors are completely inside
motor coupler cover and not pinched between the
motor coupler cover and motor.
Slide the motor coupler cover over the downrod and
rotate the cover until the threaded studs protrude
(Figure 8).
Install the two #8 external tooth lockwashers and #8-32
knurled knobs (supplied) to secure the motor coupler
cover (Figure 8).
3.9
Pass the 80-inch long motor leads through the opening
in the ceiling cover. Be sure the cover is oriented
correctly (Figure 9).
3.10
Reinstall the hanger ball (Figure 9) on the downrod as
follows. Route the motor leads through the downrod.
Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan wobble.
3.11
The fan comes with blue, black and white leads that are
80-inches long. Before installing the fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and strip
back insulation 1/2-inch from end of leads.
12/4/13 10:15 AM Page 7
3. Ceiling Fan Assembly
(continued)
7/8"
Figure 7
DOWNROD
MOTOR
COUPLER
COVER
Figure 8
PIN
DOWNROD
CEILING
COVER
Figure 9

WARNING

!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
Please contact 1-800-654-3545 for further assistance
7
#8-32 x 1-1/4"
THREADED
STUD (2)
MOTOR
#8-32 KNURLED
KNOB (2)
#8 EXTERNAL
TOOTH
LOCKWASHER (2)
#8-32 x 1-1/4"
THREADED
STUD (2)
HANGER BALL
SETSCREW
emersonfans.com
U.L. Model No.: CF4900