Final Assembly; Using Your Ceiling Fan; Warning; Turning - Emerson PREMIUM SELECT CF4801AB00 Owner's Manual

1. Screw the two 1-1/4" threaded studs (provided) into
the tapped holes in the hanger bracket.
2. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 13).
3. Secure the ceiling cover in place by sliding
lockwashers over the threaded studs and installing
the two knurled knobs (supplied). (Figure 13.)
Tighten the knurled knobs securely until the ceiling
cover fits snugly against the ceiling and the hole in
the ceiling cover is clear of the pipe.

WARNING

!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
1. Screw three 25-watt (maximum) candelabra base
lamps (supplied) into the uplight sockets on top of the
fan housing assembly (Figure 14).
2. Slide the large pendant onto the the speed control
pull chain, secure by connecting the coupling to the
chain. Slide the pendant onto the accent light pull
chain, secure by connecting the coupling to the
chain. (Figure 15).
3. Assembly of the ceiling fan is now complete. Restore
electrical power to the branch circuit at the fuse box
or breaker panel.
4. When controlled by a wall switch, check the
operation of accent light by gently pulling on the
2-position accent light control pull chain. (This switch
has the shorter pull chain.) The speed control
operating sequence is as follows:
THREE-SPEED
1st Pull—HIGH 2nd Pull—Medium
3rd Pull—Low 4th Pull—OFF
5. When operated by an Emerson Remote Control,
check operation of fan and light in accordance with
the Remote Control Owner's Manual.
6. All fans are shipped from the factory with the
reversing switch positioned to circulate air downward.
7. If airflow is desired in the opposite direction, turn the
fan off and wait for the blades to stop turning. Then
slide the reversing switch, located on switch cup, to
the opposite position (Figure 15) and turn the fan on
again. The blades will turn in the opposite direction
and reverse the airflow.

6. Final Assembly

7. Using Your Ceiling Fan

10
1-1/4"
THREADED
STUD
KNURLED KNOB
Figure 13
25-WATT (Max.) CANDELABRA
BASE LAMPS (3)
Figure 14
ACCENT LIGHT
SPEED CONTROL
PULL CHAIN
PULL CHAIN
PENDANT
COUPLING
Figure 15
Reverse Switch Information
Season Rotation Direction
Summer Counter-Clockwise
Winter Clockwise
CEILING COVER
LOCKWASHERS (2)
UPLIGHT
SOCKETS (3)
REVERSE
SWITCH
LARGE
PENDANT
COUPLING
Switch Position
Right
Left
U.L. Model No.: CF4801 and CF4501