How To Wire Your Ceiling Fan; Warning; Turning; Grounded As A Precaution Against Possible Electrical - Emerson SOUTHTOWNE CF4900BS00 Owner's Manual

BP7485 Southtowne CF4900
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
5.1
Pull the wire leads, coming from the end of the
downrod, and the supply wires through the open side of
the hanger bracket. (Figure 14).
5.2
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except
for the ground wire.
12/4/13 10:15 AM Page 10

5. How to Wire Your Ceiling Fan

WARNING

WARNING
DOWNROD
RCK55
RECEIVER
CEILING
COVER
Figure 14
Position the RCK55 Receiver (supplied) in the ceiling
cover so that the flat side of the receiver faces up and
the open portion of the receiver is to the right, as shown
in Figure 14.
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal injury
or property damage.
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
10
U.L. Model No.: CF4900