Warning - Emerson LURAY ECO CF860BQ00 Owner's Manual

BP7515 CF860 Luray Eco
9.3
Your wall control has code switches which must be set
in one of 32 possible code combinations (Figure 41).
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position.
Change the switch settings as follows:
Slide the five switch levers in the wall control to your
choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the levers firmly up
or down.
The sixth switch marked ON and I is for dimming
control of lights: Set switch to ON to allow for dimming
of the lights. Set switch to I for no dimming of the light
kit.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
9.5
This control is designed to operate only one ceiling fan
NOTE: Electric connections should be in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
Remove the faceplate and screws from the existing wall
switch. Pull switch out from wall outlet box.
Determine the "hot" wire and the "load" wire and
disconnect these wires from existing control
(Figure 42).
Do not attempt to disconnect any wires not already
connected to existing control.
1/4/16 2:35 PM Page 22
9. Wall Control Installation

WARNING

CAUTION:
(Continued)
Figure 41
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except
for the ground wire.
9.4
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan wall control into the outlet box.
FACEPLATE
SCREWS
Figure 42
22
WALL CONTROL
CODE SWITCHES
1 - 5
ON
1 2 3 4 5
I
DIMMING
SWITCH
I
CODE
SWITCHES
WALL
CONTROL
OUTLET
WALL BOX
SWITCH
ETL Model No.: CF860