I Microsoft Windows 2000 - Icom ID-RP1 Instruction Manual

3
DRIVER INSTALLATION
I Microsoft
q Connect the ID-RP1D/VS [SERVICE ] connector
and the PC USB port through an USB cable and
connector converter.
• Turn the power ON.
• "Found New Hardware" dialog box appears below.
w The "Found New Hardware Wizard" will come up as
below. Click [Next>].
e Select "Search for a suitable driver for my device
(recommended)", then click [Next>].
r Select "CD-ROM drives", and insert the supplied
CD into the CD drive, then click [Next>].
12
® ®
Windows 2000
Click
Select
Click
Select
Click
t When the driver is found, the following dialog is dis-
played. Click [Next>] to start the installation.
NOTE: When the appropriate driver is not found, a
different dialog is displayed. In such case, click
[<Back], select "Specify a location", click [Next>],
then type "D:\driver" in the text box to select the "Dri-
ver" folder in the CD (if CD drive is D).
y After the installation is completed, click [Finish].
u The "Found New Hardware" wizard appears again.
i Click [Next>].
Click
Click
Click