External Siren Test; Internal Siren Test; Strobe Test; Bosch Security Systems | 12/05 | Blcc110U - Bosch Solution 64 User Manual

3. Use the [ ] and [ ] keys to scroll the cursor left and right
across the output name text. Use the [ ] and [ ] keys to
scroll through the different characters available. To clear all
text from the cursor position to the right, press the [OFF]
key.
4. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Outputs > Output Testing >

External Siren Test

This menu allows you to test any external sirens which have been
connected by your installer. The test will last for 5 seconds.
1. Enter [MENU] + [4] + [9] + [0].
If the system has been partitioned, the keypad will display a
list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS
2. Use the [ ] and [ ] keys to select the area that you want to
test the siren, then press [OK]. Alternatively, you can enter
the area number, then press [OK].
The keypad will display the following during the siren test.
External Audible
Testing Press any key to
abort
Press OK or MENU
When the siren test is complete, the keypad will display the
following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >

Internal Siren Test

This menu allows you to test any internal sirens which have been
connected by your installer. The test will last for 5 seconds.
1. Enter [MENU] + [4] + [9] + [1].
If the system has been partitioned, the keypad will display a
list of areas.

Bosch Security Systems | 12/05 | BLCC110U

MENU 4-9-0
OK or MENU
MENU 4-9-1
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS
2. Use the [ ] and [ ] keys to select the area that you want to
test the bell, then press [OK]. Alternatively, you can enter
the area number, then press [OK].
The keypad will display the following during the bell test.
Internal Audible Testing
Press any key to abort
Press OK or MENU
When the bell test is complete, the keypad will display the
following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >

Strobe Test

This menu allows you to test the external strobe light.
1. Enter [MENU] + [4] + [9] + [2].
If the system has been partitioned, the keypad will display a
list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS
2. Use the [ ] and [ ] keys to select the area that you want to
test the strobe, then press [OK].
Alternatively, you can enter the area number, then press
[OK].
The keypad will display the following during the strobe test.
Strobe Activated. Will
Reset On exit
Press OK or MENU
Check and verify that the strobe light is on.
3. Press [OK] to exit.
Solution 64 | User Guide
OK or MENU
MENU 4-9-2
OK or MENU
19