Bosch Solution 64 User Manual page 25

Trouble Condition
Mains Missing
Battery Low
Battery Missing
Battery Reversed
Voltage Low
Voltage High
RF Rxer Missing
RF Rxer Tamper
RF Rxer Jammed
Comms Trouble R1
Comms Trouble R2
Comms Test Fail
Buss Trouble
Default PIN Trbl
Date And Time
Cabinet Tamper
Siren Trouble
Telco Line Trouble
LAN Overload
Comm+ Overload
Accessory Overld
Time For Service
Memory Fault
Default Memory
Service Mode
Phone In Use
Bosch Security Systems | 12/05 | BLCC110U
The system has detected that the AC mains supply has failed or is disconnected. If there is not a general power outage
in your area then you should contact your security company.
The backup battery has failed the periodic test which the system performs on a regular basis. You should contact your
security company as the battery may need replacing.
The system has detected that its backup battery has been disconnected.
The system has detected that backup battery has not been connected correctly.
You should contact your security company.
The voltage reading the keypad has fallen below the minimum programmed by the security company.
The voltage reading at the keypad has increased above the maximum programmed by the security company.
The system has detected that the RF receiver is disconnected.
The system has detected that the tamper circuit on the RF receiver is faulted.
The system has registered a jamming fault from the RF receiver. This situation may preven certain parts of your system
from working correctly. You should contact your security company.
The system has failed to send reports to the primary report contact. You should contact your security company.
The system has failed to send reports to the secondary report contact.
You should contact your security company.
The system has failed to send its periodic report to the monitoring station.
You should contact your security company.
The system has failed to communicate to a system device (e.g. keypad etc).
The system has detected that either the Installer PIN or User 1 PIN has not been changed from the factory default codes.
These codes should be changed immediately to prevent a security risk.
The system date and time needs to be set.
The system has detected that someone has tampered with its metal enclosure or that it has been forced open. Inspect
and contact your security company if necessary.
The system has detected that the external siren has failed or has been disconnected from the system.
The system has detected that its telephone line has been disconnected for a minimum of 30 seconds.
The system has detected that the current load has exceeded the maximum LAN rating.
You should contact your security company.
The system has detected that the current load has exceeded it's maximum COMM+ rating.
You should contact your security company.
The system has detected that the current load has exceeded it's maximum ACCS+ rating.
You should contact your security company.
The system displays this trouble condition to remind you that a service call is due.
The system has detected an error with its internal memory. You should contact your security company.
The system memory has reset to factory default. You should contact your security company.
The security installer has entered service mode.
The system is using the phone line.
Description
Table 5: Solution 64 Trouble
Solution 64 | User Guide
25