Table of Contents
Advertisement
Outputs > Output Testing >
External Siren Test
This menu allows you to test any external sirens which
have been connected by your installer. The test will last for
5 seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [0].
If the system has multiple areas, the keypad will
display a list of areas.
A1 Security System
A2 Area 2 Name
A3 Area 3 Name
Press
2. Use the [] and [] keys to select the area that you
want to test the external sirens in, then press [OK].
Alternatively, you can enter the area number, then
press [OK].
The keypad will display the following during the
siren test.
External Audible Testing
Press any key to abort
Press OK or MENU
When the siren test is complete, the keypad will
display the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >
Internal Siren Test
This menu allows you to test any internal sirens which have
been connected by your installer. The test will last for 5
seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [1].
If the system has multiple areas, the keypad will
display a list of areas.
A1 Security System
A2 Area 2 Name
A3 Area 3 Name
Press
2. Use the [] and [] keys to select the area that you
want to test the internal sirens in, then press [OK].
Alternatively, you can enter the area number, then
press [OK].
Bosch Security Systems 3/23 BLCC610U
MENU 4-9-0
OK or MENU
MENU 4-9-1
OK or MENU
The keypad will display the following during the
internal siren test.
Internal Audible Testing
Press any key to abort
Press OK or MENU
When the test is complete, the keypad will display
the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >
Strobe Test
This menu allows you to test the external strobe light.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [2].
If the system has multiple areas, the keypad will
display a list of areas.
A1 Security System
A2 Area 2 Name
A3 Area 3 Name
Press
2. Use the [] and [] keys to select the area that
you want to test the strobe in, then press [OK].
Alternatively, you can enter the area number, then
press [OK].
The keypad will display the following during the
strobe test.
Strobe Activated. Will
Reset on exit
Press OK or MENU
Check and verify that the strobe light is on.
3. Press [OK] to exit.
Outputs > Output Testing >
Fire Siren Test
This menu allows you to test any sirens programmed as fire
which have been connected by your installer. The test will
last for 5 seconds.
Enter programming mode (PIN + MENU) then,
Solution 6000
User Guide
MENU 4-9-2
OK or MENU
MENU 4-9-3
29
Advertisement
Table of Contents
