Right-Hand Handlebar Switch; Engine-Stop Switch; Electric Start Button - KYMCO People S 250 Owner's Manual

CONTROLS & FEATURES
Locking the steering
Turn the handlebar fully to the left. Press in and rotate the
ignition switch key counterclockwise to the "LOCK
sition. The steering will now be locked. Remove the ignition
switch key.
After locking the ignition switch, turn the handlebar gen-
tly to confirm that the steering is locked. Do not park
your scooter in a position that will interfere with vehicle
or pedestrian traffic.
Do not turn the ignition switch to the lock position when
riding, as this could cause the steering to lock, and you
could lose control of your scooter.
Unlocking the steering
Insert and rotate the ignition switch key clockwise from the
"LOCK " position to the "OFF
The steering is now unlocked, and you may start and oper-
ate the scooter.
12
" po-
" or "ON " position.
Right handlebar switch
Engine stop switch 1 1 1 1 1 :
The engine stop switch turns off the ignition, stopping the en-
gine. The scooter's lights and horn still function.
Electric starter button 2 2 2 2 2 :
Press the electric starter button to activate the starter motor.
NOTE: The starter motor will not engage unless a brake le-
ver is squeezed at the same time the starter button is pressed.
To prevent damage to the starter motor, do not operate
the starter motor for more than five seconds at a time. If
the scooter fails to start immediately, check the fuel level
and the battery condition, and allow the starter motor to
cool before attempting to start the engine again.
1 1 1 1 1
2 2 2 2 2