DIR-620 Multifunction Wireless Router Supporting WiMAX,
3G GSM/CDMA with Built-in Switch
User Manual
PPTP + Dynamic IP or L2TP + Dynamic IP Connection
In the Name field, specify a name for the connection for easier identification and click the Next
button.
If needed, in the MTU field, change
If your ISP uses MAC address binding, in the MAC field,
ISP upon concluding the agreement.
You can click the Clone MAC button to set the MAC address of the network interface card (of the
computer that is being used to configure the router at the moment).
Also you can set the address of a device connected to the router's LAN at the moment. To do this,
select the relevant value from the drop-down list located to the right of the field (the field will be
filled in automatically).
Figure 43. Configuring PPTP + Dynamic IP WAN connection.
Figure 44. Configuring PPTP + Dynamic IP WAN connection.
the maximum size of units transmitted by the interface.
enter the MAC address registered by your
Page 50 of 159
Configuring via Web-based Interface