Table of Contents
Advertisement
General Installation Process
18
Install Intel® Remote Management Module 4 (optional)
Installing the Intel® RMM4 Lite
A
Locate the RMM4 Lite connector close to the Riser Slot 2, carefully
pickup the Intel
RMM4 Lite module, match the alignment pin of the
®
module and the connector on server board, then press to install.
19
Install Second Power Supply Module (optional)
A
Use the 'finger hole' to remove the
filler panel.
A
20
Install Bezel (optional)
NOTE: Before installing the bezel, you must install the rack handles.
A
Lock the right end of the front bezel to the rack handle.
B
Push in the left side of the bezel until it clicks into place.
B
A
B
Insert the power supply module into the power
supply cage and push all the way until it clicks
into place.
Finger Hole
A
Installing the Intel® RMM4 NIC
A
Push out and remove the metal cover on the chassis where the NIC RJ-45
receptacle will align.
B
Position the module over the server board, fit the front of the module into
the back panel slot, then attach the module to the server board connector.
C
Secure the module with the two screws as shown.
C
B
Power Supply Removal
Using the handle, pull the module from the
chassis while pressing the green latch in the
direction shown.
B
21
Install the Top Cover
A
Place the top cover on system and slide towards the front of chassis
until the recessed front edge is fully engaged.
B
Install the three screws at the front and torque to 7-9in-lbs, then
install the screw at the back and torque to 7-9in-lbs.
A
Recessed
Edge
9
A
Chassis Back
Opening
Filler
AF005068
B
A
Advertisement
Table of Contents
