NVS480R User's Guide
5.6. Alarm Device Setup
The configuration of the alarm device output when triggered by an alarm device input (senor or motion
detection) can be configured on this page, including an output device port test and triggered condition.
Alarm Device
Test: Test alarm devices. Press On/Off for testing. This option will manually trigger the output
device 1 and 2 to the "ON" and "OFF" state. It can be used in a new setup or for troubleshooting external
devices.
Alarm Device Active
Condition: Set up the condition in which to trigger the output devices 1 and 2. A
- Duration: Set the active duration of Alarm Out from the moment of the trigger.
10 sec, 30 sec, 1 min, 2 min, 5 min, 10 min, 30 min, 1 hour.
Figure 5-8. Alarm Output Setup
combination of input sensors and motion detection can trigger the
output device to activate.
- 29 -