Sensor & Capture Setup - Inscape Data AirGoggle NVS 480R User Manual

NVS480R User's Guide
5.5. Sensor & Capture Setup
This is the setup page for the conditions of video capture. Video capture can be triggered either by activating
either alarm sensor or motion detection as set up by this page. When the sensor is triggered, the event is
ported to the NVR100 Software. Captured video of the event can be stored on the HDD of the NVS480R.
Sensor Setup: Up to 4 external sensors can be connected to the NVS480R.
- Type Selection: Select sensor type. There are two sensor operating modes.
. Normal Open: Open circuit in normal operation.
condition.
. Normal Close: Closed circuit in normal operation. An open circuit indicates an-alarm triggered
condition.
Video Capture Condition: Sets which sensor will trigger video recording for channels 1-4. The NVS480R
1. Sensor: when at least one of the sensors detect a trigger event.
2. Motion-detected: Motion triggered event from the video channel.
NOTE: Both conditions are mutually independent in operation.
Figure 5-7. Sensor & Capture Setup
supports 2 types of sensor event triggers.
- 28 -
A closed circuit indicates an alarm-triggered