Table of Contents
Advertisement
NVS440R User's Guide
2. Motion-detected : Motion triggered event from the video channel
NOTE: Both conditions are mutually independent in operation.
5.6. Alarm Device Setup
The configuration of alarm device output when triggered by an alarm device input(senor or motion detection)
can be configured in this page, including output device port test and triggered condition.
"
Alarm Device Test
: Test alarm devices. Press On/Off for testing. This option will manually trigger the output
device 1 and 2 to "ON" and "OFF" state. It can be used in new setup or troubleshooting external devices.
"
Alarm Device Active Condition
- Duration : Set the active duration of Alarm out from the moment of the trigger.
10 sec, 30 sec, 1 min, 2 min, 5 min, 10 min, 30 min, 1 hour.
Figure 5-8. Alarm Output Setup
: Setup the condition in which to trigger the output device 1 and 2. A
combination of input sensor and motion detection can trigger the
output device to activate.
- - - - 29
29 - - - -
29
29
Advertisement
Table of Contents
