Waste Toner Feeder Pu - Brother HL-2700CN Service Manual

4.29

Waste Toner Feeder PU

1) Remove the setscrew (BT3x8, 2 pieces) to remove the cover C.
2) Remove the setscrew (BT3x8, 1 piece) to remove the plate.
3) Remove the waste toner feeder PU from the frame.
Note:
• One end of waste toner feeder PU is supported by the hole inside the frame.
• In this instance, as the waste toner may leak from the toner feeder part in the
pipe, prepare the waste toner tray to prevent the waste toner from falling on the
floor.
• Clean the inside of the printer, if any stain, with the vacuum cleaner that is for the
toner only.
• It would be better to apply a grounding wire to the vacuum cleaner to prevent
static charge.
• Vacuum the toner remained in the waste toner feeder pipe.
Cover C
Hooks
BT3x8
Fig.7-36
VII-32
Frame
Waste toner feeder PU
BT3x8
Plate