Brother HL-2700CN Service Manual page 141

Code No.
14 CHECK WASTE TONER PACK
14 CHECK WASTE
15 MISPRINT
15 MISPRINT
16-1
ALIGN FU.UNIT
16 ALIGN
LCD Message
TONER PACK[*4]
[*6] [*4]
FU.UNIT [*4]
V-16
Description of Message
• Engine is idling.
• Alarm LED is lit.
• Replace the waste toner pack with a
new pack.
• This message will be automatically
cleared by open & close operation of
the paper exit cover taking place
while replacement of the waste toner
pack. The message is cleared also by
pressing the - Key.
• Engine is idling.
• Alarm LED is lit.
[*6] Kind of the misprint will be indicated
as follows;
NOPQR: No PRREQ-N signal is
available.
PAPER: No paper is available in
the feeder while executing
the print operation after
receipt of the print
command.
MEDIA: While executing the print
process after receipt of
print command, the media
type of feeder is not
consistent with the
specified media type.
Misprint occurred while the
Duplex printing.
• This message can be cleared by
pressing the - Key.
• Engine is standstill.
• Alarm LED is lit.
• Fuser unit is not installed. Reconfirm
the installation status of the fuser
unit..
• This message will be automatically
cleared by open & close operation of
the paper exit cover. The message is
cleared also by pressing the - Key.