Table of Contents
Advertisement
User Manual of Network Video Recorder
9.4 NTP Settings
Purpose:
A Network Time Protocol (NTP) Server can be configured on your NVR to ensure the accuracy of system
date/time.
Steps:
1.
Enter the Network Settings interface.
Configuration> Remote Configuration> Device Parameters> Time Settings
2.
Select the NTP tab to enter the NTP Settings interface, as shown in Figure 9. 7
3.
Check the Enable NTP checkbox to enable this feature.
4.
Configure the following NTP settings:
•
Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.
•
NTP Server: IP address of NTP server.
•
NTP Port: Port of NTP server.
5.
Click Save to save the settings.
Note:
The time synchronization interval can be set from1 to 10080 minutes, and the default value is 60 minutes. If
the NVR is connected to a public network, you can use a NTP server that has a time synchronization function, such
as the server at the National Time Center (IP Address: 210.72.145.44). If the NVR is setup in a private network,
NTP software can be used to establish a NTP server for time synchronization.
Figure 9. 7 NTP Settings Interface
60
Hide quick links:
Advertisement
Table of Contents
