Email Settings - HIKVISION Network Digital Video Recorder User Manual

User Manual of Network Video Recorder

9.5 Email Settings

Purpose:
The system can be configured to send an Email notification to all designated users if an alarm event is detected,
etc., an alarm or motion event is detected or the administrator password is changed.
Before configuring the Email settings, the NVR must be connected to a local area network (LAN) that maintains
an SMTP mail server. The network must also be connected to either an intranet or the Internet depending on the
location of the e-mail accounts to which you want to send notification.
Steps:
1. Enter Email settings interface:
Configuration> Remote Configuration> Network Settings> Email
2. Configure the following Email settings:
Enable Server Authentication (optional): Check the checkbox to enable the server authentication feature.
User Name: The user account of sender's Email for SMTP server authentication.
Password: The password of sender's Email for SMTP server authentication.
Confirm: Repeat the password you input before.
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
SMTP Port No.: The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL (optional): Click the checkbox to enable SSL if required by the SMTP server.
Interval: The interval refers to the time between two actions of sending attached pictures.
Attached Image(optional): Check the checkbox to enable the function of attaching image when send email.
Sender: The name of sender.
Sender's Address: The Email address of sender.
Select Receivers: Select the receiver. Up to 3 receivers can be configured.
Receiver: The name of user to be notified. Up to 3 receivers can be modified.
Receiver's Address: The Email address of user to be notified.
3. Click Save button to save the settings.
Figure 9. 8 Email Settings
61