Ntp - HIKVISION DS-7608NI-L1/W User Manual

Before You Start
Enable the UPnP™ function of your router if UPnP™ is required. When the device network working
mode is multi-address, the default device route should be on the same network segment as the
LAN IP address of the router.
Steps
1. Go to Configuration → Network → General → NAT .
2. Turn on Enable.
3. Select Mapping Type as Manual or Auto
Auto The port mapping items are read-only, and the external ports are set by the router
automatically. You can click Refresh to get the latest status of the port mapping.
Manual Select an external port type. Click
external port No., or change it according to actual requirements. External Port
indicates the port No. for port mapping in the router.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while
the value of the other ports should be between 1 and 65535 and the value must be
different from each other. If multiple devices are configured for the UPnP™ settings
under the same router, the value of the port No. for each device should be unique.
4. Set the virtual server of your router, including internal source port, external source port, etc. The
virtual server parameters shall be corresponding with your device port.

6.2.4 NTP

Your device can connect to a network time protocol (NTP) server to ensure that the system time is
accurate.
Steps
1. Go to Configuration → Network → General → NTP .
2. Turn on Enable.
3. Enter the parameters.
Interval
Network Video Recorder User Manual
Figure 6-6 NAT
to edit External Port. You can use the default
47