Ntp; Log Server Settings - HIKVISION DS-7100NI-Q1/P Series User Manual

6.2.4 NTP

Your device can connect to a network time protocol (NTP) server to ensure that the system time is
accurate.
Steps
1. Go to Configuration → Network → General → NTP .
2. Turn on Enable.
3. Enter the parameters.
Interval
Time interval between two time synchronization with NTP server.
NTP Server
IP address of the NTP server.
4. Click Apply.

6.2.5 Log Server Settings

Upload Logs to the Server
You can upload system logs to the server for backup.
Steps
1. Go to Configuration → Network → General → Log Server Settings .
2. Turn on Enable
3. Set Upload Time Interval, Server IP Address, and Port.
4. Optional: Click Test to test if parameters are valid.
5. Click Apply.
Network Video Recorder User Manual
Figure 6-7 Log Server Settings
40