Cli: Tftp/Ftp Software Download To The Access Point; Using The Web Interface To Download Software From The Local; Computer - HP ProCurve 420 Management And Configuration Manual

File Transfers
Downloading Access Point Software
A-6

CLI: TFTP/FTP Software Download to the Access Point

CLI Commands Used in This Section
Command Syntax
copy <ftp | tftp> file
dir
reset <board | configuration>
The following example shows how to download new code to the access point
using a TFTP server. After downloading the software file, you must reboot the
access point.
HP420#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>:
TFTP Source file name:hp420-2022.bin
TFTP Server IP:10.1.0.9
HP420#dir
File Name
--------------------------
dflt-img.bin
hp420-2022.bin
syscfg
syscfg_bak
262144 byte(s) available
HP420#reset board
Reboot system now? <y/n>: y
Using the Web Interface To Download Software From
the Local Computer
This procedure assumes that:
A software file for the access point has been stored on the local computer.
■
(The access point software file is typically available from the HP ProCurve
website at http://www.hp.com/go/hpprocurve.)
CLI Reference Page
page 6-31
page 6-33
page 6-6
[1]:1
Type File Size
---- -- ---------
2 1325119
2 1325119
5 17004
5 17004