HP ProCurve 420 Management And Configuration Manual page 63

To set the SSID to "RD-AP#3" and display it, enter the CLI commands shown
in the following example.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless g)#ssid RD-AP#3
HP420(if-wireless g)#show
Wireless Interface Information
===========================================================
----------------Identification-----------------------------
Description
SSID
Radio mode
Channel
Status
----------------802.11 Parameters--------------------------
Transmit Power
Max Station Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
DTIM Interval
Maximum Association
----------------Security-----------------------------------
Closed System
WPA mode
Multicast cipher
Unicast cipher
WPA clients
Authentication Type
Encryption
Default Transmit Key
WEP Key Data Type
Static Keys :
Key 1: EMPTY Key 2: EMPTY
===========================================================
HP420(if-wireless g)#
Access Point Configuration
Modifying System Information
: Enterprise 802.11g Access Point
: RD-AP#3
: 802.11b only
: 3
: Enabled
: FULL (18 dBm)
: 11Mbps
: 2346 bytes
: 2347 bytes
: 100 TUs
: 2 beacons
: 128 stations
: DISABLED
: Dynamic key
: WEP
: TKIP
: SUPPORTED
: OPEN
: DISABLED
: 1
: Hexadecimal
Key 3: EMPTY Key 4: EMPTY
5-7