How To Move Between Levels - HP ProCurve 420 Management And Configuration Manual

Using the Command Line Interface (CLI)
Using the CLI
3-6

How To Move Between Levels

Change in Levels Example of Prompt, Command, and Result
Exec level
HP420#config
to
HP420(config)#
Global configuration
level
Global configuration
HP420(config)#interface ethernet
level
HP420(if-ethernet)#
to a
Context configuration
level
Move from any level
HP420(if-ethernet)#end
to the preceding level
HP420(config)#end
HP420#
Move from any level
HP420(if-ethernet)#exit
to the Exec level
HP420#
HP420(config)#exit
HP420#
Changing Parameter Settings. Regardless of which interface is used (CLI,
or web browser interface), the most recently configured version of a param­
eter setting overrides any earlier settings for that parameter. For example, if
you use the web interface to configure an IP address of "X" for the Ethernet
interface and later use the CLI to configure a different IP address of "Y", then
"Y" replaces "X" as the IP address for the Ethernet interface.
—or—