HP ProCurve 420 Management And Configuration Manual page 30

Using the Command Line Interface (CLI)
Using the CLI
HP420(config)#?
Configure commands:
8 02.1x
a ddress
e nd
e xit
f ilter
h elp
i app
i nterface
i p
l ogging
m ac-authentication
n ative-vlanid
n o
p assword
p rompt
r adius-server
s nmp-server
s ntp-server
s ystem
u sername
---More---
When - - MORE - - appears, use the Space
bar or [Return] to list additional
Figure 3-4. Example of the Configuration-Level Command Listing
3-8
Typing ? at the Configuration level produces this listing:
Set 802.1x
Set address
Return to pre vious mode
Exit to the E XEC mode
Bridge protoc ol filtering
Description o f the help system
Enable IAPP
Into the inte rface configure mode
Set IP
Modify messag e logging facilities
Set RADIUS MA
Set Native VL AN ID <1-4095>
Negate
Assign the pr ivileged password(max length:16)
Set system's
Set radius se rver
Modify SNMP p arameters
Set SNTP
Set system na me
Set username
When - - MORE - - appears, there are more commands in the listing. To list the
next set of commands, press the Space bar. To list the remaining commands
one-by-one, repeatedly press
Typing? at the Global Configuration level or the Context Configuration level
produces similar results. In a particular context level, the first block of
commands in the listing are the commands that are most relevant to the
current context.
Use To Complete a Command Word. You can use
[Tab]
complete the current word in a command. To do so, type one or more
consecutive characters for a command and then press
allowed). The CLI completes the current word (if you have typed enough of
C Authentication
prompt
.
[Enter]
to quickly
[Tab]
(with no spaces
[Tab]