Never Exceeded 400Rpm Due To An Unbalanced Load - Maytag 27" Troubleshooting Manual

Diagnostic Codes
Diag. Description
Code
1 No Drain
The door
fails to
2
unlock
3 No Fill
The door
4 fails to lock
5-7
Water level
8
sensor fault.
9
Unbalance
detected
during final
spin, which
10 prevented
the spinner
from
exceeding
400 rpm
Water
E sensor level
fault.
Will not
remember
11
machine
settings
12-14
Trigger
The water level fails to drop below the Low
Water level reset within 15 minutes, before
a spin begins.
Door failed to unlock after 3attempts
Continuous fill of 12 minutes. Total fill of
14minutes.
Door failed to lock after 3 attempts
Input signal from water level Sensor
is out of range, Washer will beep and
pause the wash cycle.
Never exceeded 400rpm due to an
unbalance load.
Water level in the machine is believed to be
above the overflow level. When this
condition is detected, the machine will
automatically begin pumping water out of
the machine until it falls below the overflow
level.
Difficulty in reading memory
Displays "nd"
Go to "Will Not Drain"
Troubleshooting Section
Displays "LO" Go to "Will Not
Unlock" Troubleshooting Section
Displays "nF"
Go to "No Water Fill"
Troubleshooting Section
Displays "FL" Go to "Will not lock"
Troubleshooting Section.
Not Used
Not Used
LED – Will display "dc"
Go to "Wet Clothes
"Troubleshooting Section"
First check to see that water valve
is not stuck. If water valve is OK,
check water level sensor
Go to "Clear diagnostic codes"
Disconnect and reconnect the
washer power cord at power
supply outlet.
If condition still exists, replace
machine control board.
Not Used
17
Action to be taken
Displays "LE"
Go to "No water fill
Troubleshooting".