Maytag 27" Troubleshooting Manual page 15

Slide 9
LED/Switch Test
While in Service Mode, press the Delay key to start a LED/Switch check. All the
LED's can be toggled or slewed by pressing the key associated with the LED or set of LED's. All
keys (including the OFF button) must be pressed within 5 minutes for this test to pass. "PA" will be
displayed for five (5) seconds once all keys have been pressed and the test is completed. Following
20seconds of inactivity at any point, this test will exit without any display. The Power Off switch pad
must be pressed twice within 30 seconds to cancel this test.
Press
LED/Switch Test
While in Service Mode, press the Delay key to start a LED/Switch check.
All the LED's can be toggled or slewed by pressing the key associated
with the LED or set of LED's. All keys (including the OFF button) must be
pressed within 5 minutes for this test to pass. "PA" will be displayed for
five (5) seconds once all keys have been pressed and the test is
completed. Following 20seconds of inactivity at any point, this test will exit
without any display. The Power Off switch pad must be pressed twice
within 30 seconds to cancel this test.
Refer to Technical Data Sheet for Detailed Instructions
Switch
Delay Start
Chime
Extra Rinse
Soil Level
Spin Speed
Temperature
Rinse&Spin
Spin Only
Prewash
Extended Spin
Selector Knob
Selector Knob
Start Pause
Selector Knob
Power Off
LED/ Switch Test
Action
Press once
Press 3 times
Press once
Press 4 times
Press 5 times
Press 5 times
Press once
Press once
Press once
Press once
Rotate 1 full revolution clockwise
1 position counterclockwise
Press once
Press once
Press once
11