Typical Full Load Sizes - Maytag MAT20MNBKW Installation Instructions Manual

This appliance is intended to be used in
n
household and similar applications such
as staff kitchen areas, shops, offices, other
working environments, farm houses. It can
also be used by clients in hotels, motels,
other residential type environments, bed
and breakfast type environments, areas
for communal use in blocks of flats, or
in launderettes.
No washer can completely remove oil. Do not
n
dry anything that has ever had any type of oil
on it (including cooking oils). Doing so can
result in death, explosion, or fire.
It is recommended that fiberglass items not
n
be washed in coin-operated washers. If
these items are washed in the washer, run
the washer through a complete cycle to rinse
away any residue that might be left in the
washer.
Cleaning and user maintenance by children
n
must be supervised.
Do not allow children to play on, in, or with
n
the washer. Close supervision of children
is necessary when the washer is used near
children.
Before the washer is removed from service
n
or discarded, remove the door or lid.
Do not reach into the washer if the basket,
n
tub, or agitator is moving.
Water Heater set to 49°C (120°F).
n

TYPICAL FULL LOAD SIZES

Load Type
Mixed Load
Permanent Press
4
SAVE THESE INSTRUCTIONS
(7.7 kg maximum load size)
Loading Suggestion
3 double sheets
4 pillowcases
6 pair shorts
8 T-shirts
2 shirts
2 blouses
8 handkerchiefs
2 double or 1 king size sheet
1 tablecloth
1 dress
1 blouse
2 slacks
3 shirts
2 pillowcases
Do not install or store the washer where it will
n
be exposed to the weather.
Do not tamper with controls.
n
After installation, access to mains plug or
n
mains supply via a double-pole switch must
be maintained at all times in order to ensure
immediate deactivation of the washer in case
of emergency.
Do not repair or replace any part of the washer
n
or attempt any servicing unless specifically
recommended in this manual. You must also
understand these instructions and have the
skills to carry them out.
See "Electrical Requirements" for grounding
n
instructions.
Water pressure of 138–690 kPa (20–100 psi)
n
is needed for operation of the washer.
Use new hoses supplied with the washer.
n
Do not reuse old hoses.
If the supply cord is damaged, it must be
n
replaced by the manufacturer, its service
agent, or similarly qualified persons in order
to avoid a hazard.
IEC capacity: 7.7 kg.
n
Washer installation and service must be
n
performed by a Maytag authorized service
person.
Do not use an extension cord or an electrical
n
portable outlet device.
Load Type
Heavy Work Clothes
Knits
Loading Suggestion
3 pair pants
3 shirts
1 coverall
4 pair jeans
1 overall
3 blouses
4 slacks
6 shirts
4 tops
4 dresses