Automatic Lint Filtering System; Safety Spin; Unbalanced Spin Load Compensator; Overload Protector - Maytag HAVS-1 Use & Care Manual

Special Features
Automatic Lint Filtering System
The Lint Filtering System does not require
cleaning.
Wash and rinse water is filtered and re-filtered
continuously to trap lint shed by most fabrics during
the agitation cycle before it can be redeposited on the
wash load. The engineered hole design on the wash
basket in conjunction with water flow produced by the
agitator, traps lint away from the clothes between the
inner wash basket and the outer tub. Lint is
automatically flushed from the washer during the spin
cycle.
Safety Spin
If for any reason you open the washer lid when the
washer is in a spin or extract period, the operation will
immediately stop. This is for your personal safety. If
your washer does not stop, call your service technician
immediately. When the lid is closed, the operation will
automatically resume.
Unbalanced Spin
Load Compensator
Your new washer is designed to handle out-of-balance
loads without shutting down or interrupting the
washing cycle.
For this reason, the cycle will always be completed. If
heavier fabrics in such out-of-balance loads should
ever contain excessive moisture at the completion of
the cycle, redistribute the clothes in the washer and
reset the control dial for the final spin period.
Overload Protector
A built-in protector automatically shuts off the washer
motor in case of an overload. This can occur if:
, The load being washed is too heavy.
, Too many appliances are plugged into the line
operating your washer.
, A low voltage condition exists on the line.
, Lid is opened and closed repeatedly.
The overload protector permits the washer to start
again when the motor has cooled to a safe operating
temperature.
If the motor stops repeatedly, call your service
technician.
10