Quick Service Cycle - Maytag 27" Troubleshooting Manual

Slide 8

Quick Service Cycle

While in Service Mode, pressing the Temperature and Soil
Level key for 3seconds will start a Quick Service Cycle.
This will be a quick check of all systems. If display shows od
then open and close door. Pressing Spin Speed will advance
to the next cycle. The following steps are performed: Display
shows "SC".
Refer to Technical Data Sheet for Detailed Instructions
Quick Service Cycle
While in Service Mode, pressing the Temperature and Soil Level key for
3seconds will start a Quick Service Cycle. This will be a quick check of all
systems. If display shows od then open and close door. Pressing Spin Speed will
advance to the next cycle. The following steps are performed: Display shows "SC".
1. Hot water for 5 seconds and then turn off.
2. Cold water for 5 seconds and then turn off.
3. Bleach valve for 5 seconds and then turn off.
4. Dispenser softener using cold water and bleach water for 5 seconds and then turn off.
5. Turn on Cold valves until the control detects proper water level. During this time, tumble at
45 rpm for 5seconds in a clockwise direction, pause for 2seconds, tumble at 45 rpm for 5
seconds in a counterclockwise direction, pause for 2 seconds. Continue pattern until the
water level is detected. Minimum time for this segment to be 5 seconds. After water height is
achieved, continue tumble pattern for another 14 seconds. If the washer is equipped, turn on
heater for first 5 seconds of this tumble pattern. Advance the washer to next step if water is
not connected to machine.
6. Drain and spin to maximum speed. Machine will achieve maximum speed using the safest,
fastest method.
7. Display a "PA" (Passed) continuously for 5 seconds I no diagnostic codes were logged
during the test. Washer will return to the normal Service Mode at the end of the 10 second
period.
The "SC" in the display will blink as an indication of failure, and continue blinking until the quick
service cycle test has reached the end. Any diagnostic code logged during this test will result in
failure of the test, but will not necessarily stop the test. During the Quick Service Cycle, pressing the
Spin Speed key will advance to the next step. Pressing the Rinse&Spin and Spin Only keys will
suspend the machine at the current step for up to 10 minutes or until Delay Start and Chime are
pressed again. All LED's should flash on and off while the system is suspended or on hold.
Press and hold 3 sec.
10
Quick Service Cycle