Board Input Test - Maytag 27" Troubleshooting Manual

Slide 10

Board Input Test

While in Service Mode, pressing the Spin Only key will
begin the Board Input Test. This test turns on a specified
output after a key press. Pressing the Spin Only key again
cancels the test. (Display shows in). While in Service Mode
follow chart to check respective function.
Refer to Technical Data Sheet for Detailed Instructions
Board Input Test
IN
While in Service Mode, pressing the Spin Only key will begin the Board Input Test.
This test turns on a specified output after a key press. Pressing the Spin Only key again
cancels the test.(Display shows in).While in Service Mode follow chart to check
respective function.
•
When the "Rotary Cycle Selector" is set to "Super Wash" and the "Rotary Cycle Selector" is
pressed, the door position will be displayed: "OP" if open, "CL" if closed.
•
When the "Rotary Cycle Selector" is set to "Normal" and the "Rotary Cycle Selector" is
pressed, the Lock position will be displayed: "UL" if unlocked, "LO" if locked.
•
When the "Rotary Cycle Selector" is set to "Whites "and the "Rotary Cycle Selector" is
pressed, the High water level will be displayed: "
High water level is defined as the over flow water level.
•
When the "Rotary Cycle Selector" is set to "Wrinkle Control" and the "Rotary Cycle
Selector" is pressed, the Medium water level will be displayed: "-0" if below level, "-1" if
above level. The Medium water level is defined as the minimum water level needed to turn
the heater on.
•
When the "Rotary Cycle Selector" is set to "Colors" and the "Rotary Cycle Selector" is
pressed, the Low water level will be displayed: "_0" if below level, "_1" if above level. The
Low water level is defined as the reset water level.
Press
Board input Test
– 0" if below level, "
12
– 1" if above level. The