Maytag 27" Troubleshooting Manual page 7

Noisy and/or Vibration/Walking
•
Check if the washer was properly leveled and the locking nuts are securely tightened up
against the base frame of the washer.
•
Check and determine all four of the shipping bolts and spacers have been fully removed from
the rear panel of the washer.
•
Check for proper load size and distribution. If clothes load is too small, add a few towels to
balance the clothes load better.
•
Check the tightness of the rear pulley bolt. Tighten if necessary.
•
Clean floor and bottom side of washer feet. Check clearance. Refer to the back of machine
and Installation Instruction.
Rubber Feet Leaving Marks on Floor
•
Use a pencil eraser to remove mark.
•
Walk washer into location, do not drag.
Additive Cups Full of Water
•
Small amount of water in bottom of additive cups is normal.
•
Remove and wash Dispenser Tray, removable Cup, and Rinse Cap.
•
Level washer.
•
Buttons do not Respond
•
Option and Function buttons respond differently according to each cycle.
•
Child Lock feature has been selected. To disable feature press and hold Wash/Rinse Temp
and Spin Speed simultaneously until a beep is heard.
•
When display shows "End", only the Power Off button will function. Press Power Off and
make new cycle selections.
If the consumer observes codes on display, see table below.
LED
Display
The water level fails to drop below the Low Water level
nd
reset within 15 minutes, before a spin begins.
Door failed to unlock after 3 attempts.
LO
Continuous fill of 12minutes. Total fill of 14minutes.
nF
Door failed to lock after3 attempts.
FL
Water sensor level fault.
LE
A fault is detected in the water level sensor. Data
(frequency) shows the water level is at or above the
OE
overflow level.
Consumer Information Codes
Description
3
Diagnostic code
1
2
3
4
8
E