Table of Contents
Advertisement
Linux Driver Support
2. Run the "depmod" command to update the module configuration:
# depmod
3. Next, run the "mkinitrd" command to update the initrd file:
# mkinitrd
4. If you are using the lilo boot loader, run lilo again:
# lilo
Step 5 Configure System to Mount Volumes during Startup
The system can be instructed to automatically mount the array(s) during startup by
modifying the file"/etc/fstab".
For example, add the following line to tell the system to mount /dev/sda1 to location /
mnt/raid after startup:
/dev/sda1 /mnt/raid ext2 defaults 0 0
4 - Updating the Driver
To update the driver, simply reinstall the driver following the steps in previous
section, " Install RocketRAID driver on an Existing System ".
Note: If the driver is loaded in initrd (when system is installed onto a disk or array
attached to the RocketRAID host adapter), you need to run the mkinitrd to command
to update the initrd file. If you are using the lilo boot loader, run lilo again (# lilo).
5 - Uninstalling the Driver
To uninstall the RocketRAID 3522 driver
Note: The driver cannot be uninstalled while the system is booted from a disk or array
attached to the RocketRAID host adapter.
To uninstall the driver, remove the lines added to /etc/modules.conf and /etc/fstab.
6-11
Advertisement
Table of Contents
