Table of Contents
Advertisement
Web RAID Management Interface
To test E-mail notification:
1) Enter the necessary information for the recipient.
2) Click the
Test
button.
If the software is unable to send a test message, an error will be displayed. Double
check the recipient entries and make sure the information is correct.
Settings>SNMP
You can set three SNMP Trap IP address and trap type, this setting will be saved in the
flash. While the corresponding type of events generated, the adapter will send SNMP
Trap Messages to the designated Trap Receiver through its Ethernet interface.
If you do not use the adapter's Ethernet interface, you can setup the SNMP
configuration in the In-Band Management Service configuration page. In this case,
the in-band management service will send SNMP Trap messages through the
network interface of the host computer.
Settings>NTP
You can check the current firmware time and setup two NTP time server addresses and
select the time zone. The adapter will keep its clock synchronized with time sever.
Note: To use the NTP feature you must setup the Ethernet port of the adapter.
5-17
Advertisement
Table of Contents
