Table of Contents
Advertisement
RocketRAID 3522 Hardware Description/Installation
3 - Verifying Installation
Once the RocketRAID 3522 host adapter and hard disks have been installed into the
disk enclosure, boot-up the system to verify that the hardware is properly recognized.
1.
Power on the system. If the system detects the presence of the adapter, the
RocketRAID 3522 BIOS Utility will be displayed during bootup.
2.
Press Ctrl+H to access the RocketRAID 3522 BIOS Utility.
The BIOS Utility will display information about hard disks attached to the adapter.
Make sure all attached disks are detected by this utility. If any of the hard disks are
not detected, power down the system and check the cable connections to both the
card, and enclosure.
2-3
Advertisement
Table of Contents
